Ironton 2682050 Owner's Manual page 23

Operation – Using the Sprayer (continued)
6. Ensure tank
flushed
7. Check drain
cap
8. Fill tank
9. Ensure
chemical
mixed
10. Replace fill
cap
Ensure tank is flushed of all chemicals from prior uses.
- Chemicals can interact dangerously when mixed, and residue chemicals are
also a health hazard.
Before filling tank, ensure drain cap is securely tightened.
Add pesticide to tank through fill cap:
1. Confirm the chemical/water dilution ratios specified on the chemical
label.
2. Determine chemical and water volumes needed for the planned
application, taking into consideration that maximum tank capacity is 8
gallons.
Note: For filling gauge accuracy at the 8 gal. (30L) mark, both sides
of the tank (above the cutout for the pump) should be filled to the
same height.
3. Add chemical to the tank through the fill cap.
If the chemical is not pre-mixed, add water and pesticide concentrate in
the order prescribed on the label.
Note: Only purchase and mix as much chemical as you need for the
planned application in order to minimize chemical over-application
and the need for storing unused chemicals.
Ensure chemical is thoroughly mixed in tank.
- Stirring device should be made of metal or plastic, non-chemical absorbing
material, and then properly cleaned and stored after use.
Replace fill cap and tighten securely.
Drain cap
23