Connecting Ac Power; Power On And Off - Yamaha RMio64-D Owner's Manual

Using Optical Cables
NOTE
Optical cables of up to 2,000 meters (theoretical value) can be
used.
Redundant Connection (Input only)
You can set up a redundant connection using both 75Ω
coaxial cables and optical cables, so that there is no
input signal loss even if interference occurs in the
connection.
In addition, the input signal from the Dante network is
output from both the MADI [COAXIAL OUT] and MADI
[OPTICAL OUT] connectors, regardless of the MADI
redundancy settings.
 Settings
• To set up a redundant connection, turn on MADI DIP
switch 2 (DOWN).
• To give priority to the coaxial cables, turn on MADI DIP
switch 1 (DOWN).
• To give priority to the optical cables, turn off MADI DIP
switch 1 (UP).
NOTE
Make sure to change the settings of the DIP switches while the
power to the unit is turned off; otherwise, the ID setting will not
be effective.
Coaxial cable Optical cable
priority
RMio64-D
OPTICAL OPTICAL
OUT IN
OPTICAL OPTICAL
IN OUT
MADI-compatible device
RMio64-D
priority
MADI-compatible device

Connecting AC Power

1.
Turn the unit off.
2.
Connect the plug on the AC power cord to
the AC IN connector on the rear panel of the
unit.
3.
Connect the other side of the plug on the
AC power cord to a power supply socket.
NOTE
• When removing the AC power cord, perform these steps in
reverse.
• Press the latch button on the plug to disconnect the power
cord.
WARNING
• The RMio64-D has been designed assuming it a proper
ground connection is used. To prevent electrical shock
and damage to devices, use the included AC power cord
to create a secure ground connection. If you do not know
how to make a proper ground connection, contact a
Yamaha service center listed at the end of this manual.
• Be sure to use only the included power cord with this unit.
Use of a different power cord could result in abnormal
heat and electrical shock.
CAUTION
• Be sure to turn the power off before connecting or
disconnecting the power cord.
• Even when the power switch is turned off, a small amount
of current is flowing through the unit. When you are not
using the product for a long time, make sure to unplug the
power cord from the power supply outlet.

Power on and off

When turning on the AC power in your audio system,
always turn on the power amplifier LAST, to avoid
speaker damage. When turning the power off, the power
amplifier should be turned off FIRST for the same
reason.
RMio64-D Owner's Manual
13