Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for DEGEN DE1102
Summary of Contents for DEGEN DE1102
- Page 1 INTRODUCTION DE1102 OPERATING MANUAL PLL FM STEREO/MW.SW DUAL CONVERSION SYNTHESIZED WORLD RECEIVER ACCESSORIES Stereo Earphones Carry ing Pouch External Antenna Operating Manual AC Adaptor SIMPLE OPERATING GUIDE 3 NI-MH Rechargeable Batteries...
-
Page 2: Key Features
KEY FEATURES FM STEREO/MW/SW CLOCK FUNCTION (12H/24H) FM: 70.0-108.0 MHz, 10K/50K/100K STEP SELECTABLE TONE SELECT: NEWS OR MUSIC MW: 522-1620KHz OR 520-1710KHz, 1K/9K/10K STEP MONO/STEREO SELECTIVITY SELECTABLE FM STEREO, BASS(EARPHONES) SW: 3.00-29.99MHz, 1K/5K STEP SELECTABLE SLEEPING TIME DIRECT ENTRY 1-99 MINUTE 190 MEMORIES PRESETTING BATTERY LEVEL INDICATOR AUTO TUNE, AUTO MEMORY... -
Page 3: Table Of Contents
INDEX INDEX POWER SOURCES............1 BAND PRESET............15 OPERATING ON BATTERY..........1 ATS ..............17 OPERATING ON AC ADAPTOR........2 COPY FUNCTION............19 POWER INDICATION............3 DELETE PRESET STATIONS..........20 BATTERY CHARGE............3 RECEIVE SSB & CW............ 21 CLOCK FUNCTION............4 SET ALARM BY BEEP............ 22 SET THE CLOCK............4 AUTO POWER ON / OFF .. -
Page 4: Power Sources
POWER SOURCES When the unit is not being used for a long period of time, remove the batteries to avoid damage from battery leakage OPERATING ON BATTERY and corrosion. BATTERY INSTALLATION If battery leakage occurs, wipe the battery compartment with a soft cloth before inserting new batteries. 1. -
Page 5: Power Indication
POWER INDICATION The unit will adjust the current speed automatically during charging. The battery power is divided into 4 levels. Use NiMH batteries, and do not charge them for more than seven hours. Exhausted, auto shut off Lower When using new rechargeable batteries or those which have Full Medium not been used for a long time, charge them fully, then use them... -
Page 6: Select Time Mode
CHECK CURRENT TIME 1. When the unit is off, current time indicates in the display. 2. When the unit is on, hold down EXIT button about 0.5 second ENTER Press button 1 or 2 to display current time 3 seconds. 3. -
Page 7: Meter Band
2. Press your desired page number while P is flashing. Press METER BAND button repeatedly to select your TUNING INTO A STATION desired meter band. Manual Tuning Meter Band Circulation SW/METER DE1102 POWER LOCAL / DX SWITCH ENTER CHARGE EXIT LOCK FM ST S. -
Page 8: Auto Scan Tuning
Press any button will stop scan tuning. Scan tuning is more suitable for strong signal broadcasting, it may not stop if broadcast signals are weak. DE1102 If tuning become slowly in a frequency range, try manual POWER tuning to see if there are some weak stations. -
Page 9: Direct Frequency Entry
Press EXIT button can exit from frequency entry immediately. Quickly Input DE1102 POWER Before manual scan or auto scan, you can use quickly input function to quickly go to a frequency range. -
Page 10: Memory Scan Tuning
¼ Ç Ò ä µ ç Ì ¨ There are total 10 pages (Page 0-9) for you to preset stations. Up to 19 stations can be preset on each page. All preset stations DE1102 are permanent store. Each page is assigned as: POWER... -
Page 11: Band Preset
4. Press the desired number from 1-6 while P is flashing. 5. Press M/LOCK button , M flashes for 5 seconds. 6. Press a preset number from 1-19 to memorize the station. The DE1102 POWER corresponding number constant indicates in the display. ENTER... -
Page 12: Ats
ATS operation. 1. Set the scan method to MEMO by press SCAN button till DE1102 POWER 2. Delete the unnecessary stations by memory scan. After deleting, the unit will adjust the preset number automatically. -
Page 13: Copy Function
DELET STATIONS COPY FUNCTION All stored stations on Page 0 can be copied to other page. If copy to page 7-9, please note the band must be constant. DE1102 POWER DE1102 ENTER POWER CHARGE EXIT LOCK FM ST 4./5. S. STRENGTH SCAN Ð... -
Page 14: Set Alarm By Beep
The unit will beep when the preset time reaches. If a preset station on page1~9 is deleted, the deleted preset number is blank. It can be used on next preset. Set Beep Time RECEIVING SSB & CW DE1102 POWER DE1102 POWER ENTER... - Page 15 If power is too weak, beep function does not work. The beep sound will cover the broadcast if the unit is on DE1102 at beep time. POWER If beep and auto turn on time is set as the same, the unit will turn on after beep.
-
Page 16: Set Sleep Time
SET SLEEP TIME 3. Press number button to input the desired frequency. Press ENTER button to confirm the last preset frequency.), Then the unit goes into volume control mode. 1. Press POWER button to turn on the unit. 4. Press VOLUME + or - button to adjust the desired volume. a. -
Page 17: Lock Function
LOCK FUNCTION WIDE / NARROW BAND The lock function can be used to avoid any accidental Press AM: W/N button repeatedly to select wide band or operation when the unit is being carried or used. narrow band when listening MW or SW broadcasting. Hold down LOCK button for 2 seconds till appears in... -
Page 18: Signal Strength / Fm Stereo
SIGNAL STRENGTH / FM STEREO LISTENING WITH EARPHONES When listening to stereo reception, normally use DE1102 The unit has signal strength and POWER earphone and set MONO/STEREO button FM stereo indicator. ENTER to STEREO. ENTER In MW and SW band, light 1.2.3. -
Page 19: Using Antenna
SW Reception USING ANTENNA Telescopic antenna functions as SW antenna. Extending the FM Reception antenna straight upward to get DE1102 the best reception. POWER Telescopic antenna functions as FM ENTER CHARGE antenna, keep it extended and change EXIT LOCK FM ST S. -
Page 20: Cautions
SPECIFICATIONS CAUTIONS 1. Frequency Range Avoid exposure to temperature extremes, direct sunlight, 70.00 - 108.00 MHz moisture, sand, dust or mechanical shock. 522 - 1620 KHz Should anything go wrong with the radio, please remove 3.000 - 29.995 MHz the batteries and have the unit checked by qualified 3.160 - 3.455 MHz 11.510 - 12.155 MHz personnel before operating it any further. - Page 21 QUESTIONS & ANSWERS Q The batteries are inserted, why every button does not work except M/LOCK ? Q Does it necessary to take out of the batteries each time A Please check if indicates in the display. That means I connect the AC adaptor with the unit? the keyboard has been locked.
Need help?
Do you have a question about the DE1102 and is the answer not in the manual?
Questions and answers
translater