Back-Up Lamps - Cadillac SRX 2011 Owner's Manual

Back-Up Lamps

To replace one of these bulbs:
1. Open the liftgate. See Liftgate
on page 2 14.
A. Push Pin
B. Taillamp Cover
2. Pull on push pin (A) to release
the taillamp cover (B).
3. Remove the taillamp cover from
the lamp assembly by pulling
rearward from the top to
unfasten from snap tabs.
4. Remove the two screws from the
taillamp assembly.
5. Pull the taillamp assembly
straight back to remove.
I n f o r ma t i o n P r o v i d e d b y :
Vehicle Care
A. Turn Signal Lamp
B. Back Up Bulb/Socket
6. Disconnect the wire
harness from the back up
bulb/socket (B).
7. Turn the back up bulb socket
counterclockwise to remove it
from the taillamp assembly.
10-45