Compass; Clock (Analog Clock); Clock (Digital Clock) - Cadillac SRX 2011 Owner's Manual

Compass

The vehicle may have a compass
display on the Driver Information
Center (DIC). The compass receives
its heading and other information
from the Global Positioning
System (GPS) antenna, StabiliTrak,
and vehicle speed information.
Avoid covering the GPS antenna
for long periods of time with objects
that may interfere with the antenna's
ability to receive a satellite signal.
See Multi-Band Antenna on
page 7 19 for the location of the
vehicle's antenna. The compass
system is designed to operate
for a certain number of miles or
degrees of turn before needing
a signal from the GPS satellites.
When the compass display shows
CAL, drive the vehicle for a short
distance in an open area where
it can receive a GPS signal. The
compass system will automatically
determine when a GPS signal is
restored and provide a heading
again. See Compass Messages on
page 5 35 for more information
on the messages that may be
displayed for the compass.

Clock (Analog Clock)

The analog clock is located on the
instrument panel above the radio.
The clock is not connected with any
other vehicle system and runs by
itself. To adjust the clock:
1. Locate the adjustment buttons
directly below the clock face.
2. Push and hold either adjustment
button to advance or reverse the
clock hands. Holding the buttons
down will cause the clock to
advance faster. Release the
buttons before reaching the
desired time.
3. Push and release the buttons to
increase the time by one minute
increments until the desired time
is reached.
I n f o r ma t i o n P r o v i d e d b y :
Instruments and Controls

Clock (Digital Clock)

The infotainment system controls
are used to access the time and
date settings through the menu
system. See Operation on page 7 7
for information about how to use
the menu system. See the separate
navigation manual for instructions
on how to operate the digital clock
for the navigation system.
To turn the digital clock on or off:
1. Press the CONFIG button.
2. Select Time and Date Settings.
3. Select Clock Displayed.
4. Press MENU/SELECT to turn
the clock on or off.
5-7