JVC RX-D201S Service Manual page 8

3.1.9 Removing the power transformer
(See Fig.9)
• Remove the top cover.
Reference:
Remove the tie bands bundling the wires.
(1) Disconnect the wires from the connectors (CN106, CN111)
on the main amplifier board.
(2) Remove the soldered sections c and remove the wires.
(3) Remove the four screws P and take out the power trans-
former from the main body.
3.1.10 Removing the trans primary board
(See Fig.9)
• Remove the top cover.
Reference:
Remove the tie band bundling the wires.
(1) Remove the wires from the soldered sections c and re-
move the wires.
(2) Remove the solders from the soldered sections d and re-
move the trans primary board.
3.1.11 Removing the trans secondary board
(See Fig.9)
• Remove the top cover and power transformer.
From the side of the power transformer, remove the solders from
the soldered sections e and remove the trans secondary board.
[For Australia/China]
Trans primary
board
c
P
e
d
Trans secondary
board
Power transformer
P
[For Europe]
Trans primary
board
P
c
d
e
Trans secondary
board
Power transformer
P
Fig.9
CN106
CN111
P
Main amplifier board
CN106
CN111
P
Main amplifier board
(No.MB418)1-11