JVC RX-D201S Service Manual page 10

3.1.15 Removing the fan motor
(See Fig.12)
• Remove the top cover.
Reference:
Remove the tie band bundling the wires.
(1) Disconnect the wire from the connector
amplifier board.
(2) Remove the two screws Q.
Reference:
When attaching the fan motor assembly, attach the wire
holder with it as before.
(3) Take out the fan motor assembly.
(4) Remove the two screws R attaching the fan motor to the
fan bracket.
3.1.16 Removing the scart board
(See Fig.13) [For Europe]
• Remove the top cover.
(1) From the back side of the main body, remove the six
screws S attaching the scart board to the rear panel.
(2) From the top side of the main body, disconnect the card
wire from the connector
out the scart board from the main body.
3.1.17 Removing the speaker terminal 1 and speaker terminal 2 boards
(See Fig. 14)
• Remove the top cover and rear panel.
Reference:
Remove the tuner and subwoofer board as required.
(1) From the top side of the main body, disconnect the wires
from the connectors (CN261, CN461) on the speaker ter-
minal 1 board.
(2) Take out the speaker terminal 1 board from the main body.
(3) Disconnect the wires from the connectors (CN209, CN262)
on the speaker terminal 2 board.
(4) Take out the speaker terminal 2 board from the main body.
CN103 on the main
CN537 on the scart board and take
Fan motor
R
R
Fan bracket
Fan motor assemly
Fig.12
Scart board
S
S
Fig.13
CN209 CN461
CN262
Speaker terminal 2 board
Fig.14
Main amplifier board
Q
Q
CN103
CN537
Rear panel
CN261
Speaker terminal 1 board
(No.MB418)1-13