Advertisement
Reverse Extension Cord
ci9 Display Unit / Hide-away Unit
-I
Connecting Cord
Before you begin installation, look for the following items
which are packed with your unit.
Keep for future reference in case the product needs
~~~~
Needed for installation.
or operation of the air bag or other safety equipment OI
which interferes with operation o-f the car, it may cause
an accident.
Never use bolts or nuts from the car's safety devices for
installation, If bolts or nuts from the steering wheel,
brakes or other safety devices are used for installation
of the monitor, it may cause an accident.
Attach the wires correctly. If the wiring is not correctly
performed, it may cause a fire or an accident. In particu-
lar, be sure to run and secure the lead wire so that it
does not get tangled with a screw or the moving portion
of a seat rail.
Use with 12 volt DC negative ground car. This unit is
only for use with a 17 volt DC negative ground.car. It
cannot be used in large trucks or diesel cars which are
24 volt DC cars. If it is used in the wrong 'type of car, it
may cause a fire or an accident.
pecified fuse. Be sure to always use the
specified fuse. If a fuse other than the specified fuse
is used, it may cause a fire or an accident.
Do not damage the cord by pinching or pulling it. Do
not pull or damage the cord. If the cord is not treated
properly, it will short out or be severed and may
cause a fire or an accident.
You'll need a screwdriver and the following:
12VDC
Electrical
Test Bulb
Tape
Side-Cut
Pliers
THICKNESS
MIN. 3116" (4.75 mm)
--/j--MAX.
7/32" (5.56 mm)
\
The first step in installation is to identify all the car wires
you'll use when hooking up your LCD monitor.
As you identify each wire, we suggest that you label it
using masking tape and a permanent marker. This will
help avoid confusion when making connections later.
: Do not connect the power connector to the display
unit until you have made all connections. If there are no
plastic caps on the hooking wires, insulate all exposed
leads with electrical tape until you are ready to use them.
Identify the leads in the following order.
If your car has a radio or is pre-wired for one :
Cut the connector wires one at a time from the plug (leaving
the leads as long as possible) so that you can work with
59
Advertisement
