RCS RJC26a Owner's Manual page 23

The burners, control area, crumb pan, etc. should be kept clean at all times. During
prolonged non-use of the grill, spiders & insects can nest in areas that will adversely affect
the functioning of the grill. Check burner inlets, orifice hood (gas inlet to burner), igniter,
sparkers, etc. thoroughly and clean before use.
Fuel (Gas) Conversion Instructions for RCS grills.
This should only be performed by a licensed gas professional
Extra regulator:
Currently all grills are supplied with a regulator installed. When converting the gas
application you must also convert the regulator by removing the large nut on the front
of the regulator, pulling out the plastic orifice, flipping it over and replacing it. Tighten
the large nut and you're ready to go. (This step does not apply to the LP hose and
regulator set, only the separate regulator that comes with the grill).
In order, the regulator must be installed and converted first in order to achieve
the proper pressure to test the conversion steps 1-10 and back burner
conversion 1-3 below. To adjust the low flame setting if necessary, see next
page.........
23 | P a g e
Unscrew and remove this brass cap
Remove brass cap. This exposes the plastic
plunger
Pull off and flip over the plastic plunger and
replace in the hole. Large side down converts the
regulator to LP by compressing the interior
spring.
Replace the brass cap and you are done!!!
Note: the plunger snaps in and out of the cap.