General Information; Installation (Vewd & Dewd) - Viking VEWD173 Installation Manual

General Information

• When installing this unit directly below READ AND FOLLOW ALL WARNING
other units, only install with Viking built-
AND CAUTION INFORMATION
in products.
WHEN INSTALLING THIS APPLIANCE.
• Remove warming drawer carefully from
Moving, Handling and Unpacking
carton. Remove all loose packaging and
Remove and discard all packing materials,
accessories.
including cardboard and tape on the
outside and inside of the warming drawer.
• It is the responsibility of the installer to
comply with local codes. If no local
Some stainless steel parts may have a
codes are applicable, wire in accordance
plastic protective wrap which must be
with the National Electrical Code,
peeled off. The interior should be washed
ANSI/NFPA 70 - latestedition.
thoroughly with hot, soapy water to remove
film residues and any dust or debris before
• This appliance is not fused. Protect
being used, then rinsed and wiped dry.
with a proper sized fuse or circuit
Solutions stronger than soap and water are
breaker and a GFI for outdoor models.
rarely needed.
• Line disconnect switch, circuit breaker,
GFI (for outdoor models) or
plug/receptacle of power cord
connection should be readily accessible
to the operator.
• Ground unit per applicable electrical
codes.
• Any installation not matching the
specifications discussed in these
instructions will void the manufacturer's
warranty.
10
Installation - VEWD & DEWD
1
Pull out warming drawer
pan until fully extended.
Outdoor only Outdoor only Outdoor only
3
Apply silicone caulk around the back
of the warming drawer trim.
Note: For outdoor models ONLY.
5
Remove strain relief bracket and mounting
screws on the terminals.
11
2
1
Slide finger along right and left side until you reach the
black hand latches (located at the front of the rails). Pull
up on both the right and left latches and pull out
drawer pan support.
Electrical opening
(from rear)
4
2"
(5.1 cm)
2"
(5.1 cm)
Feed supply cord up through
hole in rear of warming drawer.
6
Attach the white (neutral) and black (line) lead
terminals. Attach ground wire to the
center terminal.