Using The Belt Clip - Datamax APEX 3 User Manual

1.4 Using the Belt Clip

The belt loop system consists of two parts:
§
A knob located on the back part of the printer just above the battery door
§
A click-on connector
To use the clip, insert the knob located at the bottom of the printer into the slot of the
connector. Pull down until a click is heard; the printer is now secure
§
To release the printer, press inward on the two (2) connector latches and pull the knob
clear of the slot.
Note: Do not force or pull the printer from the connector without pressing inward on the
two (2) latches.
FIGURE 5: KNOB CONNECTION AND QUICK CLIP
Release Latches
6