Set Up The Hardware; Charge The Battery - Logitech Network Music System User Manual

Squeezebox™ Duet User Guide

Set Up the Hardware

Charge the Battery

For this step you'll need:
• Squeezebox Controller
• Charging cradle with AC adapter
• Plug adapter for your region
• Battery
You'll start the installation process by charging the battery so it will be ready
when you configure Squeezebox Controller and Receiver for your network.
1. Select the correct plug adapter and slide it onto the AC adapter of
the charging cradle. Make sure it snaps firmly into place.
2. Plug the AC adapter into an electrical outlet.
3. Insert the battery into the Controller:
• Remove the battery cover on the back of the Controller. Use your
thumbs to press down on the battery cover, and then slide it
toward the bottom of the unit; it should move about 1/4 inch.
• Insert the battery, making sure the This Side Up label faces up
and reads correctly.
• Place the battery end–marked with three arrows–into the battery
slot first and slide it under the small plastic tab.
• Replace the battery door, fitting the tabs on the door into the
slots on the Controller.
• Slide the battery door up toward the top of the Controller so it
locks into place.
4. Place the Controller into the charging cradle. The Controller powers
on and the battery pack begins charging. It may take up to four hours
to charge the battery pack fully. However, you do not need a full
charge to set up the Controller.
7