Stabilizer; Accessories; Bench Mounting - DeWalt DW703 Instruction Manual

Series 40 60 Laser Cut Body
Woodworking Special Tooth
Geometry
Series 40 80 Laser Cut Body
Woodworking Special Tooth
Geometry

Stabilizer

Your saw includes a stabilizer (Fig.2). This must be in place and in contact with the work
surface at all times while using your saw. This stabilizer is factory installed and needs no
adjustment.

Accessories

Recommended accessories for use with your tool are available at extra cost from your local
retailer or authorized service center.
CAUTION: The use of any non-recommended accessory such as dado sets, molding
cutters, or abrasive wheels may be hazardous.
If you need assistance in locating any accessory, please contact D
Co., 701 East Joppa Road, Baltimore, MD 21286 or call 1-800-4-D
9258).
FIG. 2
REAR
GUARD
STABILIZER BAR
LEFT SIDE FENCE
CLAMPING KNOB
BENCH
MOUNTING
HOLES FOR
HOLES
EXTENSION KIT
Plastics, Corian ®
Very Smooth
and other solid Chip Free
surface materials
Non-ferrous metals Very Smooth
(aluminum, copper, Burr Free
brass, etc.)
WALT Industrial Tool
E
WALT (1-800-433-
E
OPERATING
HANDLE
GUARD
RIGHT SIDE
FENCE
TABLE
MITER
CLAMP KNOB
MITER LATCH
MITER SCALE
BASE

Bench Mounting

Holes are provided in all four feet to facilitate bench mounting, as shown in Figure 2. (Two
different sized holes are provided to accommodate different sizes of screws. Use either
hole, it is not necessary to use both.) Always mount your saw firmly to prevent movement.
To enhance the tool's portability, it can be mounted to a piece of 1/2" or thicker plywood
which can then be clamped to your work support or moved to other job sites and
reclamped.
NOTE: If you elect to mount your saw to a piece of plywood, make sure that the mounting
screws don't protrude from the bottom of the wood. The plywood must sit flush on the work
support. When clamping the saw to any work surface, clamp only on the clamping bosses
where the mounting screw holes are located. Clamping at any other point will surely inter-
fere with the proper operation of the saw.
CAUTION: To prevent binding and inaccurate cuts, be sure the mounting surface is not
warped or otherwise uneven. If the saw rocks on the surface place a thin piece of materi-
al under one saw foot until the saw sits firmly on the mounting surface.
FIG. 3
MOTOR
END CAP
SPINDLE LOCK
BUTTON
MOTOR
HOUSING
REAR
GUARD
LEFT SIDE
FENCE
MITER CLAMP
KNOB
MITER LATCH
MITER
SCALE
4
TRIGGER
CARRYING
SWITCH
HANDLE
BEVEL
STOP
DUST
SPOUT
BEVEL CLAMP
KNOB
HAND
BEVEL
INDENTATION SCALE