Table of Contents
Advertisement
Measuring
Item
instrument
Adjustment
Signal
of
generator
SUB TINT-II
Oscillo-
scope
Remote
control
unit
Y
G
R
W
Cy
Mg
B
VIDEO STATUS ADJUSTMENT
Measuring
Item
instrument
Setting
Remote
of
control unit
VIDEO
STATUS
SUB MENU: VIDEO STATUS
CINEMA
TINT
COLOR
PICTURE
BRIGHT
DETAIL
SELECT
BY
OPERATE BY
Test point
Adjustment part
TP-47B
6. TINT
TP-E (" " " " " )
[CRT
SOCKET
PWB]
(−)
0V
(B)
(+)
Test point
Adjustment part
TINT
COLOR
PICTURE
BRIGHT
DETAIL
G DRIVE
B DRIVE
R CUT.
G CUT.
B CUT.
G DRIVE
B DRIVE
R CUT.
G CUT.
B CUT.
EXIT BY
EXIT
IT
[Method of adjustment using measuring instrument]
1. Receive a NTSC 3.58 color bar signal (full field color bar 75%
white).
2. Select the sub menu screen PICTURE from the SERVICE
MENU.
3. Select 6. TINT with the MENU 1/4 key, and confirm its initial
setting value.
4. Connect the oscilloscope between TP-47B and TP-E.
5. Adjust 6. TINT to set the value (B) in the figure to +15V (W &
Mg), with the MENU 2/3 key.
NOTE: Do not adjust. Each value should be set to the initial value.
1. Select the sub menu screen VIDEO STATUS-CINEMA from
the SERVICE MENU.
2. Select TINT ~ B CUT. with the MENU 1/4 key, and reset
each value to the initial setting value on page 15, with the
MENU 2/3 key.
3. Press the VIDEO STATUS key on the remote control unit to
select VIDEO STATUS-GAME. (Each time you press the
VIDEO STATUS key, CINEMA and GAME alternates.)
4. Make similar settings as in 2 above.
No. 56083
AV-14F3PX
Description
Description
21
Advertisement
Table of Contents
