Table of Contents
Advertisement
result in damage to the device or injury to the operator. Contact a licensed service cen-
ter in case of failure
• Do not turn on the counter if the power cord is damaged
• If the device was exposed to cold for an extensive period of time, it is necessary to
keep it at the room temperature for no less than 4 hours
Remember! The producer is in no way responsible for damage to the device or injury to
the operator in the event of incorrect operation /care of the device.
6
6.1. UV detection (for PRO 57UM/S and PRO-57U models)
The UV detector is designed for various currencies and all banknote types.
The counter automatically tests the UV reflection level of the banknotes. If the level is
incorrect, the device stops counting and "Eu" error is displayed. Suspicious banknotes
will always be placed on top of the output stack. Such banknote should be verified for
authenticity. Remember that original banknotes accidentally exposed to hostile environ-
ment can also have an incorrect UV-level.
Press "UV" button to switch on the mode. The backlighting LED will light up. The UV
detector functions in any counting operation mode.
6.2. Magnetic detection (for PRO 57UM/S model)
The magnetic detector is designed for EURO and USD detection.
The device automatically tests the presence of magnetic marks on the banknote. If there
are no MG marks, the counter stops counting and "En" error is displayed. Suspicious
banknotes will always be placed on top of the output stack. Such banknote should be
verified for authenticity.
Press "E$" button to switch on magnetic detector. The backlighting LED will light up.
7
7.1. Preparation
• Connect the power cord to the device as shown in Fig. 1-6
• Turn power switch (Fig. 1-9) ON
• The "PRO" logo will appear on the screen while in batch mode
• The model type will be seen on the main screen. If an error message is shown on the
batch mode display as listed in Table 8, contact a service center
• Counter starts
• When self test mode is finished, the display will read "0" and the counter is ready for
operation
Optical density detection is switched on as default.
7.2. Counting procedure
ATTENTION! To avoid errors in counting, sort banknotes and put aside the following:
banknotes with excessive wear and tear, banknotes that have been exposed to chemi-
cals including detergents, banknotes that have unofficial markings on them, etc.
6
Counterfeit detection
Counter operation
Advertisement
Table of Contents
