PRO Intellect Technology PRO 57 User Manual page 4

-continues counting and clears error messages on display 2
-clearing counting result on the main display 1
-storing changes to the counter settings
4. "ADD" button
ON/OFF summation mode. Pressing the button once switches ON the summation mode
(indicator lights up). Pressing the button a second time switches OFF the mode.
5. "UV" button
Switch ON/OFF UV detection (by default indicator is ON)
6. "E$" button
Switch ON/OFF magnetic detection for EURO and USD (by default indicator is ON).
7. Digit buttons (0-9)
Used for entering number values on display 2 in batch mode (counting of specified
number of banknotes). Press any digit button (from 0-9) to enter batch mode
automatically.
8. "MUL" button
Automatic/manual counting mode. To start calculations in manual mode it is necessary
to press "START" button. In automatic mode (indicator is off by default) counting starts
automatically after you place a stack of banknotes in the hopper.
9. "CLR" button
This button clears the figures on display 1 and 2.
After pressing the button, the device quits batch mode and resets the summation and
counting results.
10. "SP" button
The "SP" button changes the counting speed. Each pressing of "SP" button changes the
speed. The display will depict the current speed value. After pressing "START" button,
the counter will save the set speed value and uses it in the future.
5 Safety precautions and maintenance rules
• Read this manual before operation
The manual should be available to operator.
• The device should be installed on an even horizontal surface, away from water and
dangerous objects
• Don't place the device in an area where it can be affected by direct sunlight, direction-
al artificial light, strong vibration, or dust
• Do not operate the device with wet hands
• Do not expose to water (or other liquid). Avoid foreign objects
• Avoid dropping the device
• During operation:
When finished be sure there are no banknotes in the hopper or transport system
Figure 2
• Clean the device regularly and service the device as needed at a licensed service cen-
ter to comply with the specified parameters
• Do not disassemble, repair or attempt to update the counter on your own. This can
4