Peavey TransTube 110 EFX Operation Manual page 7

( ( 1 1 5 5 ) ) R R E E V V E E R R B B
This control adjusts the overall reverb level. The surrounding LED ring indicates level.
( ( 1 1 6 6 ) ) D D E E L L A A Y Y
This control adjusts delay type, time, and volume. Three types of delay are available: SLAP (1 repeat), ECHO (3 - 4
repeats), or INFINITE (5 - 6 repeats). The LEDs in each section of the control indicate which type is active and
volume level. Pressing the control twice sets the delay time to interval between presses.
( ( 1 1 7 7 ) ) P P O O W W E E R R S S W W I I T T C C H H
Press the switch to the "ON" position to apply power to the unit.
F F o o o o t t s s w w i i t t c c h h ( ( n n o o t t i i n n c c l l u u d d e e d d ) )
EFX DELAY
CHANNEL MODULATION
SELECT REVERB
TM
PFC 3
1
2 3
DOUBLE-CLICK
PRESET
PRESET PRESET
MODE
TO STORE PRESET
18 19 20 21 22 23 24 25
M M O O D D E E S S E E L L E E C C T T
The PFC 3 footswitch operates in two modes: EFX Select mode and Preset Select mode. Pressing the MODE
SWITCH (18) selects between the two modes. The active mode is indicated by the MODE LED (19). Illumination of
the LED indicates EFX Select Mode; a dark LED indicates Preset Select Mode. Controls and indicators 20-25
perform different functions relative to the active mode.
E E F F X X S S E E L L E E C C T T M M O O D D E E
N N O O T T E E : : When entering this mode, the current preset will remain active.
In this mode, PRESET 1 (20) selects between the Lead and Clean channels. The CHANNEL LED (21) will illuminate
when the Lead channel is active. PRESET 2 (23) toggles between two effects and their respective settings. This
switch may be used as an on/off switch if one of the settings has no effects active. To use the MODULATION LED
(22) as a status indicator, the "off " (or lower setting) should be made with the LED dark, and the "on" (or higher
setting) made with the LED illuminated. PRESET 3 (25) toggles between two reverb and delay settings. As with
effects settings, this switch may be used as an on/off for reverb and delay. Both functions change simultaneously
when this switch is depressed.
P P R R E E S S E E T T S S E E L L E E C C T T M M O O D D E E
In this mode, all three switches control effects presets. Their corresponding LEDs indicate which preset is active.
Once desired settings are achieved utilizing the effects controls on the front panel, d d o o u u b b l l e e - - c c l l i i c c k k o o n n e e o o f f t t h h e e P P r r e e s s e e t t
s s w w i i t t c c h h e e s s ( ( 1 1 5 5 , , 2 2 3 3 , , o o r r 2 2 5 5 ) ) t t o o s s t t o o r r e e t t h h e e s s e e t t t t i i n n g g s s . . To return to the last saved settings for a Preset, press the desired
Preset switch once.
For a detailed explanation on creating and storing presets, refer to the TWEAK FEATURES section of this manual
on the following page.
7