ALARMS
This product is equipped with a 2-minute crescendo
alarm.
VIEW ALARM SETTINGS
Press
. The alarm time and alarm status will show
in the Clock Area.
SET ALARM
1. Press
to switch to alarm display.
2. Press and hold
again for 2 seconds. The alarm
settings will blink.
3. Select the hour and minute. Press
change settings. Press
ACTIVATE ALARM
Press
to activate or deactivate the alarm.
in the Clock / Alarm Area when the alarm is activated.
SILENCE ALARM
When the alarm time is reached, the crescendo alarm
will sound for 2 minutes. To silence the alarm:
• Press SNOOZE to silence it for 8 minutes.
OR
• Press any key except SNOOZE to mute the alarm
and activate it again after 24 hours.
If no button is pressed, the alarm will automatically
silence after 2 minutes. It will then sound again after 8
minutes.
BAR636_EN.p65
WEATHER FORECAST
This product forecasts the next 12 to 24 hours of weather
within a 30-50 km (19-31 mile) radius with 70 to 75
percent accuracy. The weather forecast is always
displayed.
SUNNY
TEMPERATURE
or
to
This product can display current, minimum, and
to confirm.
maximum temperature information collected by the re-
mote sensors and main (indoor) unit.
Outdoor data is collected and displayed every 40
seconds. Indoor data is collected and displayed every
shows
10 seconds.
SELECT TEMPERATURE UNIT
Slide the
switch is located in the main unit battery compartment.
The setting for the main unit overrides the remote
sensor setting.
SELECT CHANNEL NUMBER
Press CHANNEL to switch between sensors 1-3.
The icon shows the selected sensor.
KINETIC-WAVE
ICON
Designated
Display
To auto-scan between sensors, press and hold
CHANNEL for 2 seconds. Each sensor's data will be
displayed for 3 seconds. To end auto-scan, press
CHANNEL or MEMORY.
NOTE For more information on the sensor see
"Remote Sensor THN122N" section.
6
6
PARTLY
CLOUDY
CLOUDY
°
°
C /
F switch into the desired location. The
Indoor
Remote
Remote
Display
Display
Display
Channel 1
Channel 2
2005.2.22, 3:08 PM
RAINY
Remote
Display
Channel 3