The Set Setting Menu - Sony VPL-CX236 Operating Instructions Manual

The SET SETTING Menu

The SET SETTING menu is used for setting various functions of the projector.
Items
AUTO POWER
SAVING
With No Input
With Static Signal
Smart APA
Auto Input Search
Input-A Signal Sel.
Color System
IR Receiver
Panel Key Lock
24
The SET SETTING Menu
Item descriptions
You can make various power reduction settings.
*6
Lamp Cutoff: The lamp turns off automatically and power
consumption is reduced if no signal is input for 10 minutes. The lamp
lights again when a signal is input or any key is pressed. In Lamp
Cutoff, the ON/STANDBY indicator lights in orange. (page 33)
Standby: If no signal is input to the unit for approx.10 minutes, the
power turns off automatically, and the unit enters standby mode.
Off: You can deactivate the With No Input.
Lamp Dimming/Off: If "Lamp Dimming" is selected, the lamp dims
slowly when little or no change occurs in the image. You can choose
the period before the image darkens from "5," "10," "15," "20"
minutes or "Demo.." If you select "Demo.," the image will darken
about 30 seconds later.
On/Off: When set to "On," executes APA automatically when a signal
*1*2
is input.
On/Off: When set to "On," the projector detects input signals in the
following order: Input-A/Input-B/Input-C/Input-D/Video. It indicates
the input channel when the power is turned on or the INPUT key is
pressed.
Auto/Computer/Component/Video GBR: When set to "Auto,"
selects the type of video signal input automatically when "Input-A" is
selected with the INPUT key.
Auto/NTSC
3.58
When set to "Auto," selects the color system automatically when
"Video" is selected with the INPUT key.
The front and rear remote control detectors of the projector.
Front & Rear: The IR receivers on the front and rear of the unit are
available.
Front: The IR receiver on the front is available.
Rear: The IR receiver on the rear is available.
On/Off: When set to "On," locks all the control panel keys of the
projector. However, you can operate the following when set to "On":
• Press and hold the ?/1 key for approximately 10 seconds during
Standby mode.
c The projector turns on.
• Press and hold the ?/1 key for approximately 10 seconds during
power on.
c The projector goes to Standby mode.
• Press and hold the MENU key for approximately 10 seconds during
power on.
c "Panel Key Lock" is set to "Off" and enables operation of all keys
on the projector.
*3
/PAL/PAL-60/SECAM/NTSC /PAL-M/PAL-N:
4.43
*3