Motorola T720 Instruction Manual page 35

Level 3 Service Manual
6881040B60
8. Close the barrel of the flip on the side where the flex connector is located,
leaving open the side where the hinge assembly will be inserted into the barrel
(See Figure 17).
Figure 17. Replacing the Hinge Assembly
9. Insert the hinge assembly into the barrel. Use the flat end of the disassembly
tool to push the hinge assembly into the barrel until it is flat. Rotate the hinge
of the flip assembly into the front housing until they snap together.
10. Replace the keypad, keyboard assembly, spacer gasket, transceiver board
assembly, rear chassis assembly, antenna, battery, and battery housing as
described in the procedures.
August 01, 2002
HINGE ASSEMBLY
Disassembly
020262o
35