PetAirapy PA - 777 Instruction Manual page 10

Air sensor power settings
The unit begins to record air quality once it is plugged in. Air quality will continue to be recorded
so that the unit will turn on and off based on changes in the air quality.
ULPA
The ULPA Filter or Aluminum Electric Static Plasma Filter RESET Button
After cleaning or replacing the ULPA Filter or Aluminum Electric Static Plasma Filter, press the respective reset
ULPA
button to alert the unit to begin recording the working time of the appropriate filter.
Aluminum Electric Static Plasma
Filter & ULPA Filter RESET buttons
Disassembly and reassembly of the front panel
Use your fingertips to locate the indents on each side of the bottom front panel. With your fingertips in
place, smoothly pull the bottom front panel towards you until it disconnects from the unit. Avoid forced
disassembly with one hand.
Insert the top of the front panel to the upside of the unit. Press the bottom and top of the front panel until
it is secured in place. Then use two hands, one on each side of the middle of the front panel, and press
forward firmly until you hear each side of the panel click into place. The front panel should be flush against
the unit, it should not be bowed.
*Diagram of reassembly
ULPA
ULPA
Slip the clips into
the indentations
PA - 777 / PA PRO | 10