5. CD mecha
(1) Short-circuit the PU short land above.
(2) Remove 4 screws 51 and a screw 55.
(3) Disconnect FFC cable and Connectors.
(4) Detach Main P.W.B. and Connect P.W.B..
(5) Remove a screws 55.
(6) Detach P.W.B. frame.
(7) Remove 2 screws 56 and 2 screws 57.
(8) Detach CD mecha.
Note :
Do not pull out aslant to prevent Flat ca-
●
ble damage.
Do not fail to pull AC cord from wall outlet
●
before disconnect the Flat cable.
If AC cord is remained plugged into wall
outlet, power is kept supplied in the unit,
which may cause danger.
REMOTE CONTROL UNIT(RC-D45)
1. Cover
(1) Remove 5 screws.
Note :
Remote Control unit and its back panel are
●
connected with cables, so pay attention
when removing the back panel.
Main P.W.B.
51
51
57
Connect P.W.B.
56
CD mecha
Mecha bracket
Short land for laser diode
Remote Control Unit
5
DN-D4500 / BU4500
CX302
CX302
CX302
51
55
51
55
P.W.B. frame
56
57
PU P.W.B.
Connector
FFC cable