Subscribe to Our Youtube Channel
Related Manuals for Columbia 0616G
Summary of Contents for Columbia 0616G
- Page 1 Operator’s Manual Hydrostatic Lawn Tractor Models 0616G 6616G 6616H IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLY 772C0644A (02/03) PRINTED IN UNITED-STATES...
-
Page 2: Table Of Contents
Copy the model number here: XXXXXXXXXXX XXX-XXXXXX Copy the serial number here: COLUMBIA CANADA KITCHENER, ON N2G 4J1 CALLING CUSTOMER SUPPORT If you are having difficulty assembling this product or if you have any question regarding the controls, operation or maintenance of this unit, please call your service dealer. -
Page 3: Important Safe Operation Practices
SECTION 1: IMPORTANT SAFE OPERATION PRACTICES WARNING: This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury. -
Page 4: Slope Operation
23. Muffler and engine become hot and can cause a 3. Use slow speed. Choose a low enough speed burn. Do not touch. setting so that you will not have to stop or shift while 24. Check overhead clearances carefully before driving on the slope. - Page 5 c. Before and while backing, look behind and c. When practical, remove gas-powered down for small children. equipment from the truck or trailer and refuel d. Never carry children, even with the blade(s) it on the ground. If this is not possible, then shut off.
-
Page 6: Attachments & Accessories
Replace the blade(s) with the original equipment 10. Never attempt to make adjustments or repairs to manufacturer’s (O.E.M.) blade(s) only, listed in this the machine while the engine is running. manual. “Use of parts which do not meet the original 11. -
Page 7: Safety Labels
S30544 MAX 20 % S30011 Safety labels found on your machine... -
Page 8: Slope Guage
SECTION 3: SLOPE GAUGE... -
Page 9: Tractor Set-Up
SECTION 4: TRACTOR SET-UP Attaching the Battery Cables Service the engine with gasoline and oil as instructed in the separate engine manual packed with your tractor. Read instructions carefully. NOTE: The positive battery terminal is marked Pos. (+). The negative battery terminal is marked Neg. (–). IMPORTANT: Your tractor is shipped with oil;... -
Page 10: Know Your Lawn Tractor
SECTION 5: KNOW YOUR LAWN TRACTOR † ‡ NOTE: Steering Wheel not shown for clarity. PTO (Power Take-off) Lever (Models with manual PTO) Cruise Control Button PTO (Power Take-off) Knob (Models with electrique PTO) H Ignition Switch Systems Indicator Monitor/Hour Meter Brake Pedal Choke Control Drive Pedal... -
Page 11: Throttle Control Lever
Throttle Control Lever Refer to STARTING THE ENGINE in the OPERATION section of this manual for detailed starting instructions. The throttle control lever is located on the right side of The ignition switch is also used to operate the the tractor’s dash panel. This lever controls the speed headlights. -
Page 12: Choke Control
Choke Control PTO (Power Take-off) Lever The choke control can be found on the left side of the dash panel and is activated by pulling the knob outward. Activating the choke control closes the choke plate on the carburetor and aids in starting the engine. -
Page 13: Operating Your Lawn Tractor
Parking Brake Button NOTE: The parking brake must be set if the operator leaves the seat with the engine running or the engine To set the parking brake, fully will automatically shut off. depress the brake pedal and push the parking brake button in. IMPORTANT: Always set the parking brake when Hold the button in while taking... -
Page 14: Starting The Engine
Refer to the ADJUSTMENTS section of this manual for WARNING: Do not leave the seat of the more detailed instructions regarding various deck tractor without first placing the PTO knob (or adjustments. lever) in the disengaged (OFF) position, depressing the brake pedal and engaging the Starting the Engine parking brake. - Page 15 WARNING: • Locate the hydrostatic bypass rod in the rear of the Do not mow on inclines with a tractor. See Figure 7. slope in excess of 15 degrees (a rise of • Pull the hydrostatic bypass rod outward, then down, approximately 2-1/2 feet every 10 feet).
-
Page 16: Operating The Headlights
• Keep the throttle lever in the FAST (rabbit) position to throw the discharge to the outside for the balance for the most efficient use of the cutting deck or other of cutting. This will give a better appearance to the (separately available) attachments. -
Page 17: Making Adjustments
• Always position the throttle control lever in the NOTE: It is not necessary to remove the discharge FAST (rabbit) position and allow it to remain there chute to operate the mower with the mulch kit installed. while mowing. Failing to keep the engine at full To operate the cutting deck without mulching, simply throttle places strain on the tractor’s engine and remove the mulch plug by unthreading the plastic wing... -
Page 18: Seat Adjustment
• Measure the distance from the outside of the left • Looking at the transmission from the right side of blade tip to the ground and the distance from the the tractor, locate the compression spring and outside of the right blade tip to the ground. Both brake disc. -
Page 19: Maintaining Your Lawn Tractor
• Remove the hex nut and lock washer on the top of • Place the steering wheel in position for straight ball joint. See Figure 13. ahead travel. • Thread the ball joint toward the jam nut to shorten • In front of the axle, measure the distance the drag link. -
Page 20: Service
Engine The spark plug(s) should be cleaned and the gap reset once a season. Spark plug replacement is Refer to the separate engine manual for engine recommended at the start of each mowing season; maintenance instructions. check engine manual for correct plug type and gap Check engine oil level before each use as instructed specifications. - Page 21 Be sure to shut the engine off, WARNING: Blade Separation remove ignition key, disconnect the spark plug wire(s) and ground against the engine to prevent unintended starting before removing the cutting blade(s) for sharpening or replacement. Protect your hands by using heavy gloves or a rag to grasp the cutting Worn Blade Edge blade.
-
Page 22: Cutting Deck Removal
WARNING: Batteries give off an explosive gas while charging. Charge battery in a well Support Pin ventilated area and keep away from an open flame or pilot light as on a water heater, space heater, furnace, clothes dryer or other gas appliances. -
Page 23: Changing The Transmission Drive Belt
42” Deck Engine Pulley (or electric PTO clutch) PTO Idler Bracket Deck belt (Bottom) Left Hand Pulley (mounted on tractor) PTO belt (Top) Right Hand Pulley (beneath belt guard) Deck Idler Pulley Center Pulley Self-Tapping Screws NOTE: Left hand belt cover not shown for clarity. Figure 20 46”... -
Page 24: Hydrostatic Transmission
If you don’t, see your authorized dealer to have the belt • Roll the drive belt out from around both the v-idler changed. pulley and the flat idler pulley found on the double- idler bracket. IMPORTANT: Note the routing of the lower drive belt •... -
Page 25: Off-Season Storage
SECTION 10: OFF-SEASON STORAGE If the machine is to be inoperative for a period longer • Refer to battery storage instructions. than 30 days, prepare for storage as follows. • Store unit in a clean, dry area. • Clean the engine and the entire unit thoroughly. •... -
Page 26: Parts List
THREE (3) YEAR LIMITED WARRANTY For three (3) years from the date of original purchase of our products, we will either repair or replace, at its option, free of charge, F.O.B. Factory or authorized service firm, any part found to be DEFECTIVE IN MATERIAL and WORKMANSHIP for the original purchaser.
Need help?
Do you have a question about the 0616G and is the answer not in the manual?
Questions and answers