Using Steam And Suction Simultaneously - Vax VCST-01 User Manual

EN
Using the appliance as a steam cleaner
7.3
Please refer to the chapter "6.2 Starting up the boiler" before use.
Press the main switch (D) and the boiler switch (E), the respective
pilot lights (H) and (I) will come on. Water will start heating up and
steam will then be produced (picture 16). Pre-select the amount of
steam using the knob (J) located on the appliance.
The gauge (K) indicates the pressure inside the boiler: the
grey/silver area indicates the ideal pressure for use (picture 17).
When the pilot light (F) comes on, the appliance will be ready to
function with steam. Now press the lever (26) on the handgrip (23).
The first amount of steam will come out with water condensation;
direct the jet to one side or onto a cloth.
The handgrip (23) has a safety lock (23) which prevents steam from
accidentally escaping:
left lock: the lever is free
Note: To obtain the correct volume of steam, wait 3-4 minutes for
the water to heat up.
right lock: the lever is locked
picture 17

Using steam and suction simultaneously

7.4
Please refer to the chapter "6.2 Starting up the boiler" before use. To
steam and vacuum simultaneously: it is possible to use the above-
mentioned steam-cleaning functions together.
When work is finished, release the steam lever (26) a few moments
prior to switching off the suction motor (button 27). This will allow the
suction ducts to recover the humidity.
Note: Whilst you are working, it is normal to occasionally hear the
pump as it pumps in the water. Be careful not to confuse this noise
with audible warning signal (beep) made when the boiler water tank
is empty.
8
picture 18
9