Sharp SF-2020 Service Manual page 66

6-2. Waste toner bottle replacement (required when
waste toner full detection/maintenance)
1
Take out the process unit as shown above,
<Note> If the unit is removed by holding the toner transport pipe,
toner is spilled. Avoid this.
2
Remove the bottle cover. (2 screws)
3
Rotate waste toner bearing 1
Hole the base of toner transport pipe
time, toner may be spilled. Put a sheet under the pipe.
A
A
90 degrees counterclockwise.
B
and pull it out. (At this
B
4
While pushing waste toner bottle in the direction of
and remove.
A
(Note for assembly/maintenance)
1
As shown in the figure below, attach so that two projections of
g
gear 19T are on the rear frame side (on the screws supporting
f
plate side).
2
Replace the waste toner bottle when waste toner full is detected
or at 50K maintenance. At this time, clean and remove the waste
toner from waste toner pipe
A
6 – 18
A
and lift it
g
f
A
.