JVC MX-GT98V Service Manual page 7

Removing the front panel assembly
Prior to performing the following procedure, remove
the metal cover and CD changer mechanism
assembly.
1. Disconnect the card wires from connector CN870,
CN871 and CN315 on the main board respectively.
2.
Remove the wire clamp and disconnect the wire from
connector CN703 on the amplifier board.
3. Disconnect the wire from connector CN220 on the
transformer board.
4. Remove the two screws F
body.
5. Release the two joints a on the lower right and left
sides of the body using a screwdriver, and remove
the front panel assembly toward the front.
(See Fig.8 to 11)
on the bottom of the
MX-GT98V/MX-GT95V/MX-GT88V
MX-GT85V/MX-G78V/MX-G75V
Wire clamp
Amplifier board
CN703
Transformer board
CN220
Fig.8
(Bottom)
Fig.9
Front panel assembly
Fig.10
Joint a
Front panel assembly
Fig.11
Main board
CN870
CN871
CN315
Front panel
assembly
F
Joint a
1-7