JVC MX-GT98V Service Manual page 20

MX-GT98V/MX-GT95V/MX-GT88V
MX-GT85V/MX-G78V/MX-G75V
Removing the CD Servo control board
1.Remove the metal cover.
2.Remove the CD changer mechanism assembly.
3.From bottom side the CD changer mechanism assembly,
remove the four screws A retaining the CD servo control
board.
4.Absorb the four soldered positions "a" of the right and
left motors with a soldering absorber.
5.Pull out the earth wire on the CD changer mechanism
assembly.
6.Disconnect the connector CN854 on the CD servo
control board.
7.Disconnect the card wire CN601 and the connector
CN801 on the CD servo control board.
Removing the CD tray assembly
1. Remove the front panel assembly.
2. Remove the CD changer mechanism assembly.
3. Remove the CD Servo control board.
4. Remove the screw B' retaining the lod stopper.
5. From the T.bracket section "b" and clamper base
section "c" , remove both of the edges fixing the
rod(See Fig.2 and 3).
6. Remove the screw B retaining the disc stopper
7. Remove the three screws C retaining the T.bracket
8. Remove the screw D retaining the clamper assembly
9. From the left side face of the chassis assembly, remove
the one screw E retaining both of the return spring and
lock lever(See Fig. 4).
10. By removing the pawl at the section "d" fixing the return
spring, dismount the return spring(See Fig.4).
11. Remove the three lock levers(See Fig.4).
T.Braket
C
a
b
Clamper ass'y
1-20
(See Fig.1)
(See Fig.2~4)
(See Fig.3).
(See Fig.3).
(See Fig.3).
Disc stopper
B
C
B'
Lod stopper
(C/J version only)
C
D
Fig.3
A
a
CD servo control board
CN801
CN601
A
Fig.1
b
Rod
T.Braket
Fig.2
Lock lever
Fig.4
a
CN854
A
CN651
CN652
CN151
Earth
wire
A
Clamper base
c
d
Return spring
E