JVC MX-GT98V Service Manual page 11

Removing the power transformer
assembly (See Fig.23 and 24)
Prior to performing the following procedure, remove
the metal cover, the CD changer mechanism
assembly and the rear panel.
1. Disconnect the wires from connector CN218 and
CN219 on the power board.
2. Disconnect the wire from connector CN204 on the
regulator board.
3. Release the wire from the stopper on the regulator
board.
4. Remove the four screws L attaching the transformer
assembly.
Removing the regulator board
Prior to performing the following procedure, remove
metal cover, CD changer mechanism assembly, rear
panel, antenna board, main board, amplifier board,
voltage board, power board and speaker board.
1. Disconnect the wire from connector CN204 on the
regulator board.
2. Release the wire from the stopper on the regulator
board.
3. Remove the two screws M attaching the regulator
board.
Removing the power cord (See Fig.26)
Prior to performing the following procedure, remove
the metal cover, the CD changer mechanism
assembly and the rear panel.
1. Disconnect the wire from connector CN250 on the
power board.
2. Remove the wire clamp from the power board.
3. Move the power cord stopper upward and pull out it
from the base chassis.
CN219
(See Fig.25)
Power transformer assembly
Power cord stopper
MX-GT98V/MX-GT95V/MX-GT88V
MX-GT85V/MX-G78V/MX-G75V
Power board
CN218 Power transformer assembly
Fig.23
L
Power transformer
assembly
Fig.24
Stopper
M
Fig.25
Power board
CN250
Wire clamp
Base chassis
Fig.26
Regulator board
CN204
Stopper
L
Regulator board
CN204
M
Regulator board
CN204
1-11