SLIK SH-806E Operating Instructions page 2

Attaching the camera to the quick release platform
Remove the quick release platform turning the
lock lever.
In this case, please do not put the lock lever
back by force as it has been stood by the
stopper.
Using the pan head
Loosen the pan & tilt handle, and the head will
tilt back and forth.
Setting the pan head from the center column
Set the new head, or accessory on the tripod's threaded post, and turn
clockwise until it comes to a stop. Tighten the panning lock knob and turn
clockwise slightly more.
Care of the Tripod
・DO NOT apply any grease or oil to this product.
・Clean with a mild detergent and a soft cloth only.
・DO NOT use close to flame. Avoid extreme heat.
Slik Corporation reserves the right to make changes in design and/or improvements on the products without any obligation and advanced notice.
SLIK CORPORATION
853 Kayama, Hidaka City, Saitama 350-1231 Japan
Align the length of the platform along the base
of the camera body, and securely tighten the
mounting wing nut.
Loosen the panning lock knob, and the head will
rotate along the horizontal direction.
Phone 81-42-989-2141, Fax. 81-42-985-0210 ©2006
When you fix this quick release platform to pan
head, the quick release lock lever will return to
the original position automatically.
We, however, recommend you to tighten this
lever more to secure the fixing.
Loosen the vertical tilt handle, and the level
can be adjusted.
Removing the pan head from the center column
Use the following instructions if you wish to change to another heads, or
attach accessories.
First, lock the panning lock knob, then grasp the pan, or vertical tilt handle
and turn the head, counter-clockwise to loosen.
THINNER
OIL
Printed in Thailand.