Assembling The Grass Bag - Toro 20792 Operator's Manual

Figure 6
3. Wipe off the dipstick end with a clean cloth.
4. Insert the dipstick into the oil-fill tube, and screw it
in until it stops.
5. Remove the dipstick and read the oil level on the
dipstick; refer to Figure
•
If the oil level is too low, add a small amount of
oil slowly to the oil-fill tube, and then repeat steps
3 through 5 until the oil level is correct as shown
in Figure 6.
•
If the oil level is too high, drain the excess oil until
you obtain the correct oil level on the dipstick. To
drain the excess oil, refer to
Oil (page 17).
Important: If the oil level in the crankcase is too
low or too high and you run the engine, you may
damage the engine.
6. Install the dipstick securely by hand.
6.
Changing the Engine
4

Assembling the Grass Bag

No Parts Required
Procedure
1. Slip the grass bag over the frame as shown in
1
2
1. Handle
2. Frame
Note: Do not slip the bag over the handle
2. Hook the bottom channel of the bag onto the bottom
of the frame (Figure
7
g027257
3
Figure 7
3. Grass bag
(Figure
8).
Figure 7.
7).