Adjusting the Cutting Height
WARNING
Adjusting the cutting height may bring you into
contact with the moving blade, causing serious
injury.
• Stop the engine and wait for all moving parts
to stop.
• Do not put your fingers under the housing when
adjusting the cutting height.
CAUTION
If the engine has been running, the muffler will be
hot and can severely burn you. Keep away from the
hot muffler.
Adjust the cutting height as desired. Set all 4 wheels to the
same height.
Note: To raise the machine, move all 4 cutting height levers
forward; to lower the machine, move them all rearward
(Figure
13).
A = 3 cm (1-1/4 inches)
B = 4 cm (1-3/4 inches)
C = 6 cm (2-1/4 inches)
D = 7 cm (2-3/4 inches)
E = 8 cm (3-1/4 inches)
F = 1 1 cm (4-1/4 inches)
G = 1 1 cm (4-1/4 inches)
G027605
Figure 13
Adjusting the Handle Height
You may raise or lower the upper handle to a position
comfortable for you.
Rotate the handle lock, move the handle to 1 of 3 positions,
and lock the handle into position
Starting the Engine
1. Pull the blade-control bar to the handle
2. Pull the recoil-start handle
10
(Figure
14).
Figure 14
(Figure
Figure 15
(Figure
16).
15).