Table of Contents
Advertisement
NovaJet PROe Series
Moving the carriage
When not in use, the PROe series ink cartridges rest in the service station at the right
side of the printer. This device seals the inkjets to prevent them from drying out. If
power is turned on, always select Utility/Access Cartridges on the control panel
to move the carriage away from the service station so that you can install,
change, adjust or clean the PROe series ink cartridges, change the cutter, or
clean the service station.
Installing the cutter
A cutter located in the ink cartridge carriage cuts roll media. The printer is shipped
with the cutter installed.
!
Be careful when handling the cutter to avoid injury.
!
Cutting media with a worn cutter can cause the media to jam and create a
ragged cut line.
To install the cutter
1
Press Utility/Access Cartridge button to move the cartridge carriage to the
center of the platen.
2
The cutter fits in the printer on the left side of the carriage. Install the cutter by
pushing it into the slot until it clicks into place.
3
Press Utility/Access Cartridge to move the carriage back into the service
station. This ensures that the cutter blade is in the home position.
Filling the ink reservoirs
NovaJet PROe Series printer can support long, uninterrupted printing runs because
each of its four reservoirs holds 500 ml of ink. The ink reservoirs are located in the
printer's left side cover.
Note: When running at carriage speeds faster than the default, it is recommended that ink levels in
the reservoirs be no more than 300ml maximum.
12 Quick Start
Advertisement
Table of Contents
