Table of Contents
Advertisement
To load roll media
1
Slide the roll media onto the top roller, orienting it as shown below. Slide
the media guide into the roll core, and tighten the guide to secure the roll.
Insert the media's leading edge into the back of the printer, aligning the
paper edge with the alignment mark on the platen. The printer will sense
the presence of the media and automatically feed it.
2
If you are going to use the takeup roll, be sure that a media core is installed on
it. Attach the leading edge of the media to the takeup roll at the left, right, and
center of the core. Use at least three pieces of tape; one at each side , and
one in the middle. Orient the media as shown above.
As printing progresses, media is looped down in front of the takeup core until it
is detected by the sensor on the printer stand leg. The takeup rolls then
activated to roll the media.
Be sure not to block the sensor!
3
Press the Load/Load Media button to move the media into printing position.
4
Adjust the media edge guides.
Loading roll media
NovaJet PROe Series
Quick Start 11
Advertisement
Table of Contents
