Performance Tool M622 Owner's Manual

TROUBLESHOOTING
INSUFFICIENT POWER:
Probable Cause
Dirty or clogged air passages
Insufficient air supply
Air leakage
Worn/damaged wear & tear parts
Tool matching
LIMITED WARRANTY
PERFORMANCE TOOL® extends only the following warranties, and only to original retail purchasers. These warranties give specific legal
rights. Except where prohibited by local law, the law of the State of Washington governs all warranties and all exclusions and limitations of
warranties and remedies. There may be other rights which vary from state to state.
PERFORMANCE TOOL® warrants the product to be free from defects in materials and workmanship under normal use and service. A
defective product may be returned for a free replacement within 90 days from the date of purchase, provided that product is returned to
place of purchase immediately after discovery of defect. After 90 days and up to one year from date of purchase, PERFORMANCE TOOL®
will replace at no charge any parts which our examination shall disclose to be defective and under warranty. These warranties shall be valid
only when a sales receipt showing the date of purchase accompanies the defective product or defective part (s) being returned. For part (s)
after 90 days, please remit your request, postage prepaid to:
PERFORMANCE TOOL, P.O. Box 88259 Tukwila, WA 98138
These warranties exclude blades, bits, punches, dies, bulbs, fuses, hoses, and other consumables which must be replaced under normal
use and service. These warranties shall not apply to any product or part which is used for a purpose for which it is not designed, or which
has been repaired or altered in any way so as to affect adversely its
performance or reliability, nor shall these warranties apply to any product or part which has been subject to misuse, neglect, accident or
wear and tear incident to normal use and service.
PERFORMANCE TOOL® does not authorize any other person to make any warranty or to assume any liability in connection with its products.
Except for warranties of title and the limited express warranties set forth above, PERFORMANCE TOOL® makes no express or implied
warranties of any kind with respect to its products. In particular, PERFORMANCE TOOL® makes no implied warranty of merchantability and
no implied warranty of fitness for any particular purpose, except that for goods purchased primarily for personal, family or household use and
not for commercial or business use, PERFORMANCE TOOL® makes an implied warranty of merchantability (and, if otherwise applicable, an
implied warranty of fitness for a particular purpose), but only for the particular qualities or characteristics, and for the duration, expressly
warranted above.
The laws on limitation of implied warranties may differ from state to state, so the above limitations may not apply in all cases.
PERFORMANCE TOOL® shall not be liable for consequential, incidental or special damages resulting from or in any manner related to any
product, or to the design, use, or any inability to use the product. The sole and exclusive remedy for a defective product or part shall be the
repair, or replacement thereof as provided above. The laws on limitation of remedies or on consequential, incidental or special damages may
vary from state to state, so the above limitations may not apply in all cases.
© Copyright 2010 WILMAR CORPORATION, P.O. Box 88259 Tukwila, WA 98138
Solution
Flush and lubricate tool, drain air tank
and supply line
Increase line pressure, make sure
compressor matches tool's air pressure
and consumption needs
Use PTFE tape at all fittings and joints.
Check tool for worn or damaged O-rings
& seals.
Replace as necessary.
Be sure you are using a tool suited for
the lubing requirements of the
job at hand.
3/8 in. Dr. Single Hammer
Impact Wrench
Stock Number M622
OWNER'S MANUAL
WARNING!
READ, UNDERSTAND AND FOLLOW ALL INSTRUCTIONS AND WARNINGS BEFORE
OPERATING THIS TOOL. FAILURE TO DO SO MAY RESULT IN PERSONAL INJURY
AND/OR PROPERTY DAMAGE AND WILL VOID WARRANTY.