Related Manuals for Brightline 1.2 N
Summary of Contents for Brightline 1.2 N
-
Page 1: Operating Instructions
1.2 N/1.2 D Operating Instructions 580 Mayer Street, Building #7, Bridgeville, PA 15017 • phone 412.206.0106 • fax 412.206.0146 www.brightlines.com © 2006 Brightline, L.P... -
Page 2: Owner's Record
Model No.________________________ Serial No.________________________ Date of Purchase__________________ Product Description • The Brightline 1.2N/1.2D is a 2-lamp, 55-watt, energy-efficient light fixture. This fixture combines high-frequency electronics with a state-of-the-art optical system to produce a soft, full-spectrum, flicker-free light source. -
Page 3: Adjusting The Yoke
Installing the Yoke 1. Assemble palm handle, yoke, and washers as shown (Fig. 1). Nylon Cork Washer Washer 2. Screw palm handle into place (Fig. 2). Palm Handle Figure 1 3. Repeat Steps #1 and #2 for remaining palm handle. Note: Please refer to suplimentry manual 019-106 for vertical yoke mounting instructions. -
Page 4: Installing Lamps
Installing Lamps 1. Place lamp into clip as shown (Fig. 4). Lamp 2. Gently slide lamp into socket (Fig. 5). Note: The socket’s locking tabs will snap into Clip indents on the base of the lamp. Figure 4 3. Repeat Steps #1 and #2 for remaining lamps. Figure 5 Installing Adapters (C-Clamp/Spud) 1. -
Page 5: Installing Accessories
Installing Accessories 1. Swing latch open (Fig.8). Figure 8 2. Insert accessory into the track and slide it forward until it stops (Fig. 9). Figure 9 3. Swing latch closed and fasten in place (Fig. 10). Figure 10... -
Page 6: Replacing Fuse
Replacing Fuse 1. Pull fuse holder out of power inlet module. 2. Remove fuse holder and check for wear (Fig. 11). If fuse is blown, replace with a new fuse or the on-board spare (Fig. 12). 3. Return fuse holder to a closed position. Active Fuse On-board Spare Figure 12... -
Page 7: Troubleshooting Guide
Troubleshooting Guide Problem Possible Cause Solution Lights flicker or drop out Defective or damaged Replace with new lamps or exchange at low end. lamps. lamps from a known good fixture. Lights are flashing or Wrong voltage for ballast Verify that the ballast's voltage is strobing. -
Page 8: Specifications
Specifications Mounting: 10-gauge (.125) extruded-aluminum Housing: 14-gauge (.060) formed, yoke, welded construction (standard). aluminum sheet-metal construction. 2” O.D. pipe clamp or TVMP adapter provided. See finish note. Power Entry Module: 8-amp fuse Reflector: 24-gauge (.020) formed aluminum (with on-board spare) and IEC connector sheet-metal construction. - Page 9 Wiring Diagram - Dim Wiring Diagram - NonDim...
-
Page 10: Warranty
WARRANTY guarantees all its products to be free from defects in materials and Brightline workmanship for a period of one (1) year from the date of shipment. PROCEDURES If any product is found to be unsatisfactory under this warranty, the buyer must notify Brightline immediately. - Page 11 Notes...
Need help?
Do you have a question about the 1.2 N and is the answer not in the manual?
Questions and answers