Sangean ATS-405 Manual page 15

a. alarm by buzzer
Press and release buzzer alarm button, display will flash
the last alarm time set and buzzer alarm icon. Press
the numeric buttons to set the alarm time then press
ENTER button to complete buzzer alarm time setting.
Display will show buzzer alarm icon and back to the real
time status after a few seconds.
To cancel the buzzer alarm setting, press and hold buzzer
alarm button until a beep sounds. Display buzzer alarm icon
will disappear and buzzer alarm setting is then cancelled.
When the alarm is on, press POWER button to turn off
the alarm for 24 hours. The buzzer alarm will last for
one hour if not turned off pressing the POWER button.
You can enable the buzzer alarm again by pressing and
holding buzzer alarm button until a beep sounds, display will
appear buzzer alarm icon indicating buzzer alarm is set.
b. alarm by radio
Tune the radio to the required radio station before setting
the radio alarm. Adjust the volume control to make sure
the volume level is big enough to wake you up.
Press and release radio alarm button then follow the
procedures of setting buzzer alarm to set and cancel
the radio alarm.
4