Remove The Base Stand; Specifications - NEC AccuSync AS203WMi User Manual

Hide thumbs Also See for AccuSync AS203WMi:
Table of Contents


Remove the Base Stand

Always remove the Base Stand when shipping the LCD.
1. Place monitor face down on a non-abrasive surface (Figure R.1).
2. Using your thumb, press the button to unlock.
3. With the button pressed in, pull off the Base Stand.
Connect a Flexible Arm
This LCD monitor is designed for use with a flexible arm.
1. Follow the instructions on how Remove Monitor Stand for Mounting to remove the stand.
2. Use the 4 screws removed from the stand to attach the arm to the monitor (Figure F.1).
Use ONLY the screws (4 pcs) that were removed from the stand to avoid damage to the monitor or stand. To meet
the safety requirements, the monitor must be mounted to an arm which guaranties the necessary stability under
consideration of the weight of the monitor. The LCD monitor should only be used with an approved arm (e.g. GS
Tighten all screws.
(recommended Fasten Force: 98 - 137N•cm)


(MAX depth: 10 mm)
If use other screw,
check depth of hole.
100 mm
100 mm
Weight of LCD assembly: 2.9 kg (MAX)
Thickness of Bracket
(Arm) 2.0 ~ 3.2 mm
Tighten all screws


Table of Contents

Table of Contents