Linksys WAG325N User Manual page 9

Chapter3
VC Settings
Configure your Virtual Circuit (VC) settings in this section.
Multplexng Select LLC or VC, depending on your ISP.
QoS Type Select from the drop-down menu: CBR
(Continuous Bit Rate) to specify fixed bandwidth for voice
or data traffic; UBR (Unspecific Bit Rate) for application that
are not time-sensitive, such as e-mail; or VBR (Variable Bit
Rate) for bursty traffic and bandwidth-sharing with other
applications.
PCR For the Peak Cell Rate (PCR), divide the DSL line rate
by 424 to get the maximum rate the sender can send
cells. Enter the rate in the field (if required by your service
provider).
SCR The Sustain Cell Rate (SCR) sets the average cell rate
that can be transmitted. The SCR value is normally less
than the PCR value. Enter the rate in the field (if required
by your service provider).
Autodetect Select Enable to have the settings
automatically entered, or select Dsable to enter the
values manually.
Vrtual Crcut These fields consist of two items: VPI
(Virtual Path Identifier) and VCI (Virtual Channel Identifier).
Enter the settings provided by your ISP.
DSL Modulaton
Select
MultMode, T1.13, G.dmt, G.lte, ADSL2, ADSL2+,
ADSL2 L, ADSL2 M, or ADSL2+ M. Contact your ISP if you
are not sure which mode to use.
Follow the instructions for your type of encapsulation.
RFC 2364 PPPoA
Some DSL-based ISPs use PPPoA (Point-to-Point Protocol
over ATM) to establish Internet connections. If you are
connected to the Internet through a DSL line, check with
your ISP to see if they use PPPoA. If they do, you will have
to enable PPPoA.
Internet Connection Type > RFC 2364 PPPoA
Wreless-N ADSL2+ Gateway
the appropriate mode:
Advanced Configuration
PPPoA Settings
User Name and Password
Password provided by your ISP.
Connect on Demand: Max Idle Tme
the Gateway to cut the Internet connection after it has
been inactive for a specified period of time (Max Idle Time).
If your Internet connection has been terminated due to
inactivity, Connect on Demand enables the Gateway to
automatically re-establish your connection as soon as you
attempt to access the Internet again. To use this option,
select Connect on Demand. In the Max Idle Time field,
enter the number of minutes you want to have elapsed
before your Internet connection terminates. The default
Max Idle Time is  minutes.
Keep Alve: Redal Perod
the Gateway will periodically check your Internet
connection. If you are disconnected, then the Gateway
will automatically re-establish your connection. To use
this option, select Keep Alve. In the Redial Period field,
you specify how often you want the Gateway to check
the Internet connection. The default Redial Period is
30 seconds.
NOTE: For New
instructions:
1. Select RFC 23
Encapsulation drop-down menu.
For the Virtual Circuit ID, enter 0 for the VPI
2.
and 100 for the VCI.
Select VC for Multiplexing.
3.
4. Select Multmode from the DSL Modulation
drop-down menu.
5. Obtain the User Name and Password details
from your ISP.
RFC 2516 PPPoE
Some DSL-based ISPs use PPPoE (Point-to-Point Protocol
over Ethernet) to establish Internet connections. If you are
connected to the Internet through a DSL line, check with
your ISP to see if they use PPPoE. If they do, you will have
to enable PPPoE.
Enter the User Name and
You can configure
If you select this option,
Zealand, follow these
PPPoA from the
8