Table of Contents
Advertisement
IP Menu
The IP Menu is used to configure the IP subnets for each VLAN on your
Switch, the unicast and multicast routing protocols, and IGMP. This menu is
only available for a Switch in multilayer mode.
• Subnet Configuration - Specifies the IP interface for VLANs configured
on this Switch, including the subnet address and routing protocols.
• Protocol Configuration - Enables the unicast and multicast routing pro-
tocols globally for this Switch.
• Static ARP Configuration - Specifies the static Address Resolution
Protocol.
• Static Route - Configures a static route.
• Default Route - Defines the router to which this Switch will forward all
traffic for unknown networks.
Select OK to return to the previous panel.
48
EtherFast
Series
EtherFast
®
Select Apply to make changes. Select OK to return to the previous panel.
Select Cancel to cancel any changes. Select Prev Page to view the previous
page. Select Next Page to view the next page. To display a specific page, set
the page number in the Page field and then press Apply. Select Add to add
an IP interface.
Managed 24-Port with Dual Gigabit Switch
®
Subnet Configuration
The Subnet Configuration screen allows you to specify an IP interface for
any VLAN configured on this Switch that needs to communicate with a
device outside of its own group (that is, another network segment).
• IP Address - The IP address associated with the specified VLAN inter-
face. By convention, the last three digits should be set to "254" to readily
distinguish this device as a router port.
• Subnet Mask - A template that identifies the address bits in the host
address used for routing to specific subnets. Each bit that corresponds
to a "1" is part of the network/subnet number, and each bit that
corresponds to "0" is part of the host number.
• VLAN - The VLAN associated with this IP interface.
• RIP - Routing Information Protocol for unicast routing.
• DVMRP - Distance-Vector Multicast Routing Protocol.
49
Advertisement
Table of Contents
