Linksys Etherfast User Manual page 21

• Monitor Port - The port that will duplicate the transmitted or received
traffic appearing on the mirrored port.
Note: You can mirror multiple ports to a single port to view traffic such as
that crossing a port trunk. However, note that some packets may be
dropped for moderate to heavy loading.
Select Apply to make changes. Select OK to return to the previous panel.
Select Add to add a port.
Port Trunking Configuration
Ports can be combined into an aggregate link to increase the bandwidth of
a network connection or ensure fault recovery. You can configure trunks
between any two switches. The RJ-45 ports on this Switch can be grouped
into a trunk consisting of two, four, or eight ports, creating an aggregate
bandwidth up to 400, 800, or 1600Mbps when operating at full duplex.
• Index - The trunk identifier.
• Port Count - Trunks can contain 2, 4, or 8 ports.
• Port Number - The ports assigned to each trunk.
Select OK to return to the previous panel. Select Add to add a trunk.
36
EtherFast Series EtherFast
®
To assign a destination MAC address to one or more ports, use Add. To
delete or modify an address, highlight it with the cursor and press Enter.
Select Apply to make changes. Select OK to return to the previous panel.
Select Prev Page to view the previous page. Select Next Page to view the
next page. To display a specific page, set the page number in the Page field
and then press Apply.
Managed 24-Port with Dual Gigabit Switch
®
Static Unicast Address Configuration
The Static Unicast Address Table can be used to assign the MAC address
for a host device to a specific port on this Switch. Static unicast addresses
are never aged out, and cannot be learned on another port.
• Address - The MAC address of a host device attached to this Switch.
• Port - The switch port the host device is attached to.
37