Page 1
Use this illustration of the back of the ATA to connect it to your network. 1. Phone 1 – plug in your analog telephone cord: 2. Ethernet Port - use an Ethernet cable to connect your PAP2 to your router or modem: 3.
Page 2
1. Plus a standard telephone into the Phone 1 port of your PAP2. 2. Pick up the phone connected to Phone 1 and enter “* * * *”. You will hear a voice prompt saying “Configuration menu: please enter option followed by the pound key, or hangup to exit”.
Page 3
5. Press 1 1 1 # to access the IP Address Menu. 6. Enter your IP Address followed by # (i.e. 1 2 3 * 4 5 * 6 7 * 8 9 # to represent the IP 123.45.67.89). Press 1 to save the setting.
Page 4
ATA to upgrade its firmware. Eg, for an IP address of xxx.xxx.xxx.xxx: http://xxx.xxx.xxx.xxx/admin/upgrade?http://www.vobphone.net.au/support/hardware/linksys_pap2/firmware.bin 2. You can now enter your VOBPhone details into the Line 1 (and optionally Line 2) configuration areas. Enter your Display Name, User ID (this is your VOBPhone number) and Password.