Connection To A Wired Network For Setup; Chapter 5: Setting Up The Wireless-B Media Adapter; Overview; Setup Wizard - Linksys WMA11B User Manual

4. Press the Adapter's power button, which is located on the Adapter's front
panel.
5. The Wireless LED will light up. If it does not, then power the Adapter off
and back on again.
Proceed to "Chapter 5: Setting up the Wireless-B Media Adapter."

Connection to a Wired Network for Setup

1. Attach the antenna to the Adapter.
2. Connect the included Ethernet network cable to your PC, router, or switch.
3. Connect the other end of the cable to
the LAN port on the Adapter (see
Figure 4-4).
4. Connect the included power adapter
to the Power port on the Adapter
(see Figure 4-5).
5. Plug the power adapter into an elec-
trical outlet.
6. Press the Adapter's power button,
which is located on the Adapter's
front panel.
7. The Ethernet LED will light up. If it does not, then push the Uplink button
on the Adapter's back panel. Power the Adapter off and back on again. Make
sure the cable connections are secure.
Proceed to "Chapter 5: Setting up the Wireless-B Media Adapter."
10
Figure 4-4
Figure 4-5
Chapter 5: Setting up the
Wireless-B Media Adapter

Overview

The Wireless-B Media Adapter Setup Wizard will guide you through the instal-
lation and configuration procedure.

Setup Wizard

1. Insert the Setup CD-ROM into your CD-ROM drive. The Setup Wizard
should run automatically, and Figure 5-1 should appear. If it does not, click
the Start button and choose Run. In the field that appears, enter
D:\setup.exe (where "D" is the letter of your CD-ROM drive).
Figure 5-1
Setup - Click the Setup button to begin the installation process.
Install Utility on PC - Click the Install Utility on PC button to install the
Adapter's Utility on your PC.
User Guide - Click the User Guide button to open the PDF file of this User
Guide.
LINKSYS Web - Click the LINKSYS Web button to visit the Linksys
website, www.linksys.com.
Exit - Click the Exit button to exit the Setup Wizard.
2. To install the Adapter, click the Setup button on the Welcome screen.
11