Advertisement
Quick Links
Advertisement
Related Manuals for Outdoor GreatRoom Company Tuscany II-WB Pergola
Summary of Contents for Outdoor GreatRoom Company Tuscany II-WB Pergola
- Page 1 Tuscany II-WB Pergola Please read these instructions before removing parts from crate...
- Page 2 Introduction Thank you for your purchase from The Outdoor GreatRoom Company® . This instruction manual will guide you step-by-step through the process of assembling your Tuscany II-WB. The Outdoor GreatRoom Company® recommends visiting with your local authority for building codes, restrictions, or requirements for this product.
- Page 3 Included components for Tuscany II Pergola Columns Anchor Caps 1-5/8” Wood Screws Column Anchor Screws E L Brackets Header Beams Cross Beams...
-
Page 4: Assembly Instructions
Assembly Instructions Step 2: Step 1: 193” (outside corners) * footprint is square 136 7/8” Outside edges Place header beams (F) on top of columns in Set Columns (A) into position as shown. Do not the desired orientation and center and square anchor to a surface until all beams have been them parallel to each other and square with assembled and squared. - Page 5 Step 4: Step 3: Remove brackets and pre-drill holes in the After beams (F) are centered and squared columns with a 5/16” masonry drill bit. Place a plastic (Columns should now match up with concrete anchor into each hole, using a hammer or mallet to footing locations if applicable);...
- Page 6 Step 5: Step 6: Place a third notched crossbeam (G) centered between Place the first two notched crossbeams (G) on top the two outer beams. Then repeat this process for the of the header beams. Ensure assembly is squared remaining two notched beams, centering them in and the cross beams are centered over the col- the remaining open space.
- Page 7 Beam Securing Options: Securing Crossbeams (H) to header beams at intersection points is strongly recommended. The following methods can be used to secure beams Method A- Use an exterior grade construction adhesive to permanently secure crossbeams to header beams at joints. Method B- Pre-drill holes at a 45°...
- Page 8 Dimensional and Post Location Information NOTE 2: NOTE 1: Do not perform final tightening of Footing requirements vary by all bolts until unit is fully assem- country, state, and sometimes bled, level, and square. After even from city-to-city, so check pergola is IN POSITION, with your local regulations and SQUARED UP, &...
- Page 9 Instructions for Anchoring Tuscany Pergola to Concrete Required Materials: (X16) 3/8” concrete anchors. (Check with local building codes for proper anchor length requirements) Electric drill suitable for concrete use. ½ ” socket wrench or similar tool. Silicone adhesive suitable for outdoor use. 1.Once appropriate positions have been located for all columns and beams you will notice four (4) holes at the base of each column positioned in the orientation shown on the previous page...
- Page 10 The Outdoor GreatRoom Company extends the following warranty for Outdoor GreatRoom outdoor products used in the United States of America or Canada. Dealers and employees of The Outdoor GreatRoom Company have no authority to make any warranty or authorize any remedies in addition to or inconsistent with the terms of this warranty.
Need help?
Do you have a question about the Tuscany II-WB Pergola and is the answer not in the manual?
Questions and answers