Switching On And Off - Pro-Ject Audio Systems 2 Xperience SB DC Instructions For Use Manual

Rotate the counterweight counter clockwise (seen from the front) to adjust the downforce according to the cartridge
manufacturer's recommendations. One mark on the scale represents 1 mN (= 0,1g / 0,1 Pond) of downforce.
Please note: Adjust the downforce prior to installing the anti-skating weight.
The recommended downforce for the factory fitted cartridge is 18mN
Anti-skating force adjustment
The anti-skating force must be adjusted corresponding to the downforce as follows:
Downforce
10 - 14mN
15 - 19mN
20mN and bigger
Hang the loop of the thread of the anti-skating weight in the groove of the anti-skating stub (14) corresponding
to the downforce applied to your cartridge and feed the thread through the loop of the wire support (16).
Connection to the amplifier
The record player has gold plated female RCA phono sockets (13) so you can substitute the interconnect cables
supplied with higher quality cables such as the Pro
amplifier if you wish. Use the Phono input (sometimes labelled gram, disc or RIAA) on your amplifier. Make
sure that the phono input offers correct matching and amplification for the type of cartridge used. Line inputs
(such as CD, Tuner, Tape or Video) are not suitable.
Take care to connect the left and right channels correctly. The right channel is usually marked red, the left
channel black or white. Check the manual supplied with your amplifier for relevant information. An earthing
wire may be connected to the screw terminal between the sockets if you encounter hum problems when using
the record player.
If your amplifier does not have an input suitable for phono cartridges you will require a separate phono
amplifier stage for MM or MC cartridges which is then connected between the record player and a free line
level input of the amplifier.
For detailed product information regarding Pro-Ject Audio interconnect cables and phono amplifiers please
refer to the Pro-Ject website
The recommended load impedance for the factory fitted cartridge is: 47kohms /MM-input
Mains power connection
The turntable is supplied with the universal power supply with 3 exchangeable sockets adapters suitable for
all countries. Select the correct adapter for your country and insert the adapter to the exchangeable part of
the power supply.
Connect the low voltage plug from the power supply to the socket (12) on the rear of the record player before
connecting the power supply to the mains.
Fitting the lid
Fit the lid (dust cover 9) carefully over the hinge prongs and adjust the screws (11) until the lid stays open
where you want it to without being too stiff to open or close.

Switching on and off

Press the button START to start the turntable. For change the speed from 33 r.p.m. to 45 r.p.m., please press
the START button again. Speed is correct, when the LED diode stops blinking. To switch turntable to STAND
BY mode, please hold the button START for 3 seconds.
For detailed product information please refer to the Pro-Ject web site
© Pro-Ject Audio Systems · Pro-Ject 2 Xperience SB DC / Ortofon 2M Silver · Revision 2015.02.10
Groove in the stub (15)
st
1 from bearing rings
nd
2 " " "
rd
3 " " "
Pro- - - - Ject Connect it Pro Pro
www.project www.project- - - - audio.com audio.com. . . .
www.project www.project audio.com audio.com
18mN. 18mN 18mN
Ject Connect it interconnect cables for connection to the Ject Connect it Ject Connect it
14
www.project- - - - audio.com www.project www.project www.project audio.com. . . . audio.com audio.com
5