Operating Mode (B); Sensor Offset (O); Heating Optimisation (E) - Gira 1186 Mounting Instructions And Commissioning

Operating mode (b)

This parameter allows individual selection of the function for the radio
room temperature sensor. This defines the frequency of the radio trans-
mission (convection heater, floor heating, radio controller).
1. The + and - buttons can be used to change to one of the operating
modes listed below.
2. S activates it.
Application
Convectors, conventional
transmission interval 10 minutes
Heating circuit distributors, floor heating
transmission interval 3 minutes
Operation with radio controller,
transmission interval 10 minutes (for convection heater)
Operation with radio controller,
transmission interval 3 minutes (for floor heating)
* Factory setting

Sensor offset (o)

The measured actual temperature can be displaced by ±3.0 Kelvin
by means of this parameter. This correction can be used to compensate
the measuring deviations which arise though the unfavourable placing of
the radio room temperature sensor.
1. The + and - buttons can be used to set the parameter.
2. S saves the parameter.
The sensor offset is set to 0.0 Kelvin in our works.

Heating optimisation (E)

Function inactive
During operation with the radio controller, the heating optimisation is
inactive, as the radio controller specifies the course of the setpoint tem-
perature curve over time.
Display
10' * Only for room heating
The heating optimisation function is only suitable for room heating.
This function cannot be used for additional heaters.
3'
The heating optimisation determines the temporal behaviour of the room
F10'
on the basis of the past heating processes and calculates
the required derivative action time which is necessary in order to reach
the desired setpoint temperature on time.
F3'
The automatic heating optimization can be activated (On) and deactivated
(OFF) here. If the heating optimisation is deactivated, switching is carried
out exactly as specified in the time program.
1. The + button can be used to set the heating optimisation to On and
the - button to OFF.
2. S saves the setting.
The heating optimisation is activated (On) in our works
7