Eneo VKC-1422 Installation And Operating Instructions Manual page 56

3. SENSITIVITY
• Sets sensitivity to detect movement
• Can be set from  (low response) to 5 (sensitive)
4. INITIAL
• Initializes changed category in Motion Detection menu
5. EXIT
• Closes the sub-menu and moves to the main menu
NOTE: There is a signal every time there is movement by the subject. If motion is
detected, MD (Motion Detected) is displayed on the upper left of the screen.
This message enables the user to set On-Screen Display state in the menu.
CAUTION: Error can occur in the motion detection function in the following cases.
• When lighting is unsteady
• When light changes often even though there is no movement of the subject.
It is recommended that this function should be used after setting the detection
sensitivity and detection field after videoing the environment for an extended time.
NOTE: The detection field on screen is as follows:
WHOLE
UPPER
CENTER
OUT
56