Linksys WMP11 Quick Installation page 2

E. When the Hardware
Installation box appears,
click Continue Anyway.
E
F. When the Completing the
Found New Hardware
Wizard dialog box appears,
click Finish. If asked to
upgrade firmware, click
OK. If an error message
appears, this means the
firmware does not require
upgrading and you can
click OK again to contin-
F
ue.
G. The Installation is complete. Windows XP automatically detects and con-
figures the Wireless PCI Card for your wireless network. To adjust these
settings, refer to your Windows XP documentation.
Note: To change the settings of your Wireless PCI Card,
run the XP Zero configuration utility as shown in Step 3.
Configuring the Wireless PCI Card
using the Zero Configuration Utility
A. After installing the Wireless PCI Card, the Windows XP Wireless Zero
Configuration icon will appear on your system tray. Double-click the
icon of the two monitors.
A
B. The screen that will appear shows any available wireless network. Select
a Network from the list of Available networks, then click the Connect
button.
B
C. If your wireless network has enabled WEP encryption, you will see the
following screen. Enter the Network key, which is the WEP key, and
click the Connect button.
C
In order to find out the WEP encryption set by other wireless products in
your network, such as an access point, please check the manufacturer's
user guide for more information on WEP encryption configuration.
Note: Windows XP does not support the use of a WEP
passphrase. Enter the exact key used on your access point.
D. The Zero Configuration icon will show the network status, as shown
below, when your configuration is successful.
D
Note: For more information about WEP, refer to the User Guide
or the Linksys KnowledgeBase at www.linksys.com.
For further information on Wireless Networking with Windows
XP, search the Windows XP Search Engine using the keyword:
"wireless."
QI-WMP11-062002NC KL
W W W . L I N K S Y S . C O M