To Confi Gure World Time City And Summer Time Settings - Casio 5463 Operation Manual

World Time Mode
■ The time for my World Time City is off in the World Time Mode.
This could be due to incorrect switching between standard time and daylight saving time. See "To
confi gure World Time City and summer time settings" (page E-92) for more information.
Charging
■ The watch does not resume operation after I expose it to light.
This can happen after the power level drops to Level 5 (page E-14). Keep the watch exposed to light until
it recharges suffi ciently.
■ RECOVER is fl ashing on the digital display.
The watch is in the charge recovery mode. Wait until the recovery process is complete (about 15 minutes).
The watch will recover more quickly if you place it in a brightly lit location.
Note
• Performing repeated illumination and/or sensor reading operations over a short time period can cause
a sudden drop in watch's charge. This will cause the watch to enter the charge recover mode. The
watch is in the charge recovery mode when RECOVER is fl ashing on the digital display. The charge
recovery mode is the same as a low battery charge state, access to some functions is limited while the
watch charge is recovering. Normal operation will resume after recovery is complete. For more
information, refer to "Power Recovery Mode" (page E-16).
• A fl ashing CHARGE indicator means that the charge level of the watch has suddenly dropped.
Immediately expose the watch to light to charge it.
E-104
■ The current time setting is off by one hour.
Possible Cause Remedy
Perform the operation under "To get ready for a receive operation".
Signal reception on a day for The time setting will be adjusted automatically as soon as signal
switching between standard reception is successful.
time/daylight saving time (DST)
may have failed for some reason. If you are unable to receive the time calibration signal, change the
standard time/daylight saving time (DST) setting manually.
■ Auto receive is not performed or you cannot perform manual receive.
Possible Cause Remedy
The watch is not in the Auto receive is performed only while the watch is in the Timekeeping
Timekeeping Mode. Mode. Enter the Timekeeping Mode.
Your Home City setting is wrong. Check your Home City setting and correct it, if necessary.
There is not enough power for
Expose the watch to light to charge it.
signal reception.
■ Signal reception is being performed successfully, but the time and/or day is wrong.
Possible Cause Remedy
Your Home City setting is wrong. Check your Home City setting and correct it, if necessary.
The DST setting may be
Change the DST setting to Auto DST.
incorrect.
E-106
Altimeter:
Measurement range: –700 to 10,000 m (or –2,300 to 32,800 ft.) without reference altitude
Display range: –3,000 to 10,000 m (or –9,840 to 32,800 ft.)
Negative values can be caused by readings produced based on a reference altitude or due to
atmospheric conditions.
Measurement Unit: 1 m (or 5 ft.)
Current Altitude Data: Every second for the fi rst 3 minutes, followed by every 5 seconds for
approximately 1 hour (0'05); every second for the fi rst 3 minutes, followed by every 2 minutes for
approximately 12 hours (2'00)
Altitude Memory Data:
Manually saved records: 30 (altitude, date, time)
Auto saved values: One set of high altitude and its reading date and time, low altitude and its
reading date and time, total ascent and its save start date and time, total descent and its save
start date and time
Other: Reference altitude setting; Altitude differential (–100 to +100m/–1,000 to +1,000m); Altitude
auto measurement interval (0'05 or 2'00)
Barometer:
Measurement and display range:
260 to 1,100 hPa (or 7.65 to 32.45 inHg)
Display unit: 1 hPa (or 0.05 inHg)
Other: Calibration; Barometric pressure graph; Barometric pressure differential pointer; Barometric
pressure change indicator
Thermometer:
Measurement and display range: –10.0 to 60.0°C (or 14.0 to 140.0°F)
Display unit: 0.1°C (or 0.2°F)
Other: Calibration
E-108
Other: Battery power indicator; Power Saving; Button operation tone on/off; alarm test; auto hand position
adjustment; hand shift feature (to view digital info)
Power Supply: Solar panel and one rechargeable battery
Approximate battery operating time: 6 months (from full charge to Level 4) under the following
conditions:
• Light: 1.5 seconds/day
• Beeper: 10 seconds/day
• Direction readings: 20 times/month
• Climbs: Once (approximately 1 hour of altitude readings)/month
• Barometric pressure change indicator readings: Approximately 24 hours/month
• Barometric pressure graph: Readings every 2 hours
• Time calibration receive: 4 minutes/day
• Display: 18 hours/day
Frequent use of illumination runs down the battery. Particular care is required when using the auto
light switch (page E-98).
E-110
Operation Guide 5463
Page
E-21
E-36
Page
E-30
E-34
E-12
Page
E-34
E-34
Time Calibration Signal
The information in this section applies only when LON, PAR, ATH, HKG, HNL, ANC, LAX, DEN, CHI,
NYC, or TYO is selected as the Home City. You need to adjust the current time manually when any other
city is selected as the Home City.
■ The display shows the ERR indicator when I check the result of the latest receive operation.
Possible Cause Remedy
• You are wearing or moving the
watch, or performing a button
operation during the signal
Keep the watch in an area where reception conditions are good
receive operation.
while the signal receive operation is performed.
• The watch is in an area with
poor reception conditions.
You are in an area where signal
reception is not possible for See "Approximate Reception Ranges".
some reason.
• Check the website of the organization that maintains the time
The calibration signal is not
calibration signal in your area for information about its down times.
being transmitted for some
reason.
• Try again later.
■ The current time setting changes after I set it manually.
You may have the watch confi gured for auto receive of the time calibration signal (page E-22), which will
cause the time to be adjusted automatically according to your currently selected Home City. If this results
in the wrong time setting, check your Home City setting and correct it, if necessary (page E-34).
Specifi cations
Accuracy at normal temperature: ±15 seconds a month (with no signal calibration)
Digital Timekeeping: Hour, minutes, seconds, a.m. (A)/ p.m. (P), month, day, day of the week, barometric
pressure change indication
Time format: 12-hour and 24-hour
Calendar system: Full Auto-calendar pre-programmed from the year 2000 to 2099
Other: Three display formats (day of the week, month, day; barometric pressure change, month day;
hour, minute, second); Home City code (can be assigned one of 29 city codes); standard time /
daylight saving time (summer time)
Analog Timekeeping: Hour, minutes (hand moves every 10 seconds), seconds
Time Calibration Signal Reception: Auto receive 6 times a day (5 times a day for the Chinese calibration
signal) ; Remaining auto receives cancelled as soon as one is successful; Manual receive;
Receive Mode
Receivable Time Calibration Signals: Mainfl ingen, Germany (Call Sign: DCF77, Frequency: 77.5
kHz); Anthorn, England (Call Sign: MSF, Frequency: 60.0 kHz); Fort Collins, Colorado, the
United States (Call Sign: WWVB, Frequency: 60.0 kHz); Fukushima, Japan (Call Sign: JJY,
Frequency: 40.0 kHz); Fukuoka/Saga, Japan (Call Sign: JJY, Frequency: 60.0 kHz) ; Shangqiu
City, Henan Province, China (Call Sign: BPC, Frequency: 68.5 kHz)
Digital Compass: 60 seconds continuous reading; 16 directions; Angle value 0° to 359°; Measurement
unit: 1° (digital display)/6° (hand); North indicated by second hand: Compass calibration
(bidirectional, magnetic declination angle)
Bearing Sensor Precision:
Direction: Within ±10°
Values are guaranteed for a temperature range of 10°C to 40°C (50°F to 104°F).
North indicated by second hand: Within ±2 segments
Pressure Sensor Precision:
Measurement accuracy: Within ±3hPa (0.1 inHg) (Altimeter accuracy: Within ± 75m (246 ft.))
• Values are guaranteed for a temperature range of –10°C to 40°C (14°F to 104°F).
• Precision is lessened by strong impact to either the watch or the sensor, and by temperature
extremes.
Temperature Sensor Precision:
±2°C (±3.6°F) in range of –10°C to 60°C (14.0°F to 140.0°F)
Stopwatch:
Measuring unit: 1/100 second
Measuring capacity: 23:59' 59.99"
Measuring modes: Elapsed time, split time, two fi nishes
Countdown Timer:
Measuring unit: 1 second
Countdown range: 60 minutes
Setting unit: 1 minute
Alarms: 5 Daily alarms; Hourly time signal
World Time: 29 cities (29 time zones), UTC (Universal Time Coordinated); Home City/World Time City
switching; one-touch UTC zone access
Other: Daylight Saving Time/Standard Time
Illumination: LED light; Selectable illumination duration (approximately 1.5 seconds or 3 seconds); Auto
Light Switch (Full Auto Light operates only in the dark)
Page
E-21
E-20
–
E-105
E-107
E-109
L-1