Operation; Preliminary Steps; Operation Quick Start - Vertex Standard EVX-531 Operating Manual

Preliminary Steps

r Install a charged battery pack onto the transceiver,
as described previously.
r Screw the supplied antenna
onto the Antenna jack.
It is not recommended to op-
erate this transceiver without
an antenna connected.
r If you have a Speaker/Mi-
crophone, we recommend
that it not be connected
until you are familiar with the basic operation of
the EVX-530 series. Refer to next page for more
information about Speaker/Microphone usage.
IMPORTANT NOTE
Water resistance of the transceiver (IP57: 1
meter / 30 minutes) is assured only when the
following conditions:
r Battery pack is attached to the transceiver;
r Antenna is connected to the antenna jack;
r and MIC/SP cap is installed in the MIC/
SP jack.
r Use of a speaker microphone in the acces-
sory connector negates the IP57 rating.
EVX-530 S O
EriES pErating
o
peratIon
M
anual

Operation Quick Start

r Tu r n t h e t o p p a n e l 's
VOL/PWR knob clock-
wise to turn the radio
on.
r Turn the top panel's CH
Selector knob to choose
the desired operating
channel. A channel name
will appear on the LCD.
The radio announces the
channel number, if the Channel Announcement
Feature is enabled via the PC Programming Soft-
ware.
r If you want to select the operating channel from
a different Channel Group, press (or press and
hold) the Programmable key (assigned to the
"g " function for the EVX-531 or
c
roup hange
"g u /d " function for the EVX-534/-
roup p oWn
539) to change desired Channel Group before
selecting the operating channel.
Note: Some models are programmed so that the
15