Table of Contents
Advertisement
3. The "Welcome" screen appears. From this point, you can configure the Access
Point from one of its seven sub-menus
Setting the IP Address
The IP Address section allows you to setup IP Address, either DHCP or static IP
mode. NOTE: Changing these settings is not required in most applications
Click on the "IP Address" selection and the "IP Address" page will appear.
Actiontec recommends keeping the unit's default static IP address
(192.168.0.240), but if it conflicts with another device in the network, you can
enter a new address in the "IP Address" text box.
If your network requires the Access Point to run in Dynamic Host
Configuration Protocol (DHCP) mode which dynamically assigns an IP address,
you can change these settings from this screen.
14
Advertisement
Table of Contents
